Re: [CAD_CAM_EDM_DRO] Re: Powersupply

----- Original Message -----
From: "turbulatordude" <davemucha@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Saturday, September 27, 2003 1:48 PM
Subject: [CAD_CAM_EDM_DRO] Re: Powersupply


> --- In CAD_CAM_EDM_DRO@yahoogroups.com, Brian Fairey <bfairey@r...>
> wrote:
> > What do you reccomend as a PS to drive 3 - 201's and
> > 2 steppers NEMA 40, 2.5v, 4.5A, 2.8mH, 2200mNm, 1.8deg
> > and another motor at a lesser rating.
> > Basically I am replacing a AHHA system but can I use the AHHA
> software
> > and what do I do about the AHHA IFB board.
> > Thanks
> > Brian.
>
> www.MPJA.com, 24VAC 10A transformer, should yield about 37 volts @ 10
> amps. A little low on the max voltage, but a good price.
>
> more than enough current and for around $25.00 for the xfrmr and
> shipping it's a good deal.
>
>
> Dave
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...,
timg@...
> Moderator: pentam@... indigo_red@... [Moderators]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this to be a
sister site to the CCED group, as many of the same members are there, for OT
subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM.
DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
> bill
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>