Re: Mariss' Surplus Center Motor - Encoders
Posted by
Pat Bearss
on 2003-10-23 07:36:12 UTC
I have a Hartford Mill(a Bridgeport knockoff) it came with no
controller, power supply and missing the Y axis NMEA 42 stepper.
Would these surplus motors along with the encoders and gecko 320s and
a 70+ volt power supply be a better deal than spending $500-$600 for
a stepper replacement and going the gecko 240s.
Thanks for any advise.
Pat
controller, power supply and missing the Y axis NMEA 42 stepper.
Would these surplus motors along with the encoders and gecko 320s and
a 70+ volt power supply be a better deal than spending $500-$600 for
a stepper replacement and going the gecko 240s.
Thanks for any advise.
Pat
Discussion Thread
vrsculptor
2003-10-21 17:53:39 UTC
Mariss' Surplus Center Motor - Thanks
Mariss Freimanis
2003-10-21 20:40:18 UTC
Re: Mariss' Surplus Center Motor - Thanks
piggy
2003-10-22 08:17:28 UTC
Re: [CAD_CAM_EDM_DRO] Re: Mariss' Surplus Center Motor - Thanks
Kim Lux
2003-10-22 08:18:34 UTC
Re: [CAD_CAM_EDM_DRO] Re: Mariss' Surplus Center Motor - Thanks
Mariss Freimanis
2003-10-22 09:51:47 UTC
Re: Mariss' Surplus Center Motor - Thanks
vrsculptor
2003-10-22 09:58:28 UTC
Re: Mariss' Surplus Center Motor - Encoders
Kim Lux
2003-10-22 12:12:13 UTC
Re: [CAD_CAM_EDM_DRO] Re: Mariss' Surplus Center Motor - Thanks
piggy
2003-10-22 12:13:25 UTC
Re: [CAD_CAM_EDM_DRO] Re: Mariss' Surplus Center Motor - Encoders
vrsculptor
2003-10-22 13:00:00 UTC
Re: Mariss' Surplus Center Motor - Encoders
turbulatordude
2003-10-22 14:36:59 UTC
Re: Mariss' Surplus Center Motor - Encoders - location
skykotech
2003-10-22 14:49:27 UTC
Re: Mariss' Surplus Center Motor - Encoders
vrsculptor
2003-10-22 15:36:26 UTC
Re: Mariss' Surplus Center Motor - Encoders - location - Long
mmeyers1111
2003-10-22 19:34:52 UTC
Re: Mariss' Surplus Center Motor - Encoders
Pat Bearss
2003-10-23 07:36:12 UTC
Re: Mariss' Surplus Center Motor - Encoders