Newbie with Bobcad and bench mill drill retrofit

Hello everyone I am sure that you guys have probably seen these
questions before so please bear with me as I am new to this.. I have
just purchased a bobcad software and also in the research and buying
stages for retrofitiing my RF51 which is equivalent to a grizzly
G1006 but slightly larger bed bench mill drill. The sales guy at
Bobcad sold me the software at a show price of $249.00 for the
version 18. Now I am at the point trying to figure out how and what I
need to do with getting what I have on the computer to the servo
dirvers and get it to cut out what I have on the bench. Is the bobcad
software required to create a software to drive the movements of the
servos for me in the 45 days of free technical support? He indicated
(the salesguy) that I should not aquire the software til I am
prepared to use it as the free technical services that are offered
are not good after 45 days so I am in the process of getting alll of
the mechanical stuff out of the way beofre I recieve the osftware
next month. This way I can try and iron out all of the mechanical
stuff before the software stuff. can anyone direct me in the right
direction?I want to make sure I do an smooth transition as possible.
thanks,
Newbie George