Re: [CAD_CAM_EDM_DRO] Re: Bridgeport 440 volts to 220 volts.

Dang! The Fwd/Rev Contactors are un the upper LEFT corner, when looking
into the open door, and the Disconnect is in the upper RIGHT... I really
hate it when that happens!

RayHex

----------

> From: Raymond Heckert <jnr@...>
>
> I'm sorry I hadn't been paying too much attention to this thread. I have

a

> rigid-ram SERIES I CNC with BOSS-5 upgrade. The 'switch box' in question
> is an integtral part of the spindle housing called the "Spindle Control
> Panel". It is not located on the pendant (which is really not a pendant,
> but a movable control panel). There are no 'heaters' in either of those
> panels. The "Overload Elements" are located in the rear Main Power

Panel.

> My manual shows 1-MOL (sometimes called 1M-OL), the 'heater' ass'y is
> located between the Reversing Contactor (upper right-hand of the panel,
> when facing it thru the open door), and the disconnect switch (upper-left
> of the panel)....<snip>