CAD CAM EDM DRO - Yahoo Group Archive

Re: CCED Demise Not Going to Happen..............

Posted by Ray Henry
on 2003-12-21 08:15:32 UTC
On Saturday 20 December 2003 10:00 pm, CAD_CAM_EDM_DRO@yahoogroups.com
wrote:
> Message: 4
> Date: Sat, 20 Dec 2003 11:58:19 EST
> From: wanliker@...
> Subject: CCED Demise Not Going to Happen..............
>
> >Time to push the "end the group" button to make the Off Topic
> > Posters happy,
> >
> > > or go to moderated and If I don't like the post, just reject it.
>
> I apologize for the post......
> That post was not intended to be posted to the group. It was supposed
> to go to an individual. Called LETTING OFF STEAM
> I was angry, and suffering from a heavy cold. And accidentally posted
> it.

Been there done that -- and hung my head!

I've complained about heavihandednesshereabouts on a couple of occasions
but we are all learning. Many about machines some about lists. Bill,
when you get to old to put your arm around a good looking woman at NAMES,
then I'll start worrying about you.

Ray

BTW I included the terms "machines" and "NAMES" to get this closer to
topic. Arm is there in case someone is curious about the EMC's ability
to run a Puma 560 or a SCARA. Closer yet?

Discussion Thread

wanliker@a... 2003-12-20 08:58:28 UTC CCED Demise Not Going to Happen.............. bull2003winkle 2003-12-20 20:00:47 UTC Re: CCED Demise Not Going to Happen.............. Tim Goldstein 2003-12-20 20:48:39 UTC RE: [CAD_CAM_EDM_DRO] CCED Demise Not Going to Happen.............. bull2003winkle 2003-12-20 22:27:28 UTC Re: CCED Demise Not Going to Happen.............. turbulatordude 2003-12-21 00:12:55 UTC Re: CCED Demise Not Going to Happen.............. Ray Henry 2003-12-21 08:15:32 UTC Re: CCED Demise Not Going to Happen.............. ballendo 2003-12-21 09:04:21 UTC DIY-CNC is for beginners too!