CAD CAM EDM DRO - Yahoo Group Archive

Re: Gecko 320 with external encoder power supply

Posted by wayne_j_hill
on 2004-01-01 16:05:04 UTC
> Orange CH A+ This goes to Phase A on the
drive

> Green CH A- Where does this go?
Not Used

> Yellow CH B+ This goes to Phase B on the
drive

> Blue CH B- Where does this go?
Not Used

> Brown CH Z+ I understand that this is not used.
Not Used

> Grey CH Z- I understand that this is not used.
Not Used

> Red CH +5v +5v from my power supply goes
directly to this.

> Black Common Where does this go?
Signal Ground

> Shield Drain Where is the best place to
drain this to?
Earth Ground or Not Used

Hope this can helps

Discussion Thread

andrebarclay 2004-01-01 12:10:55 UTC Gecko 320 with external encoder power supply Gregory Kamysz 2004-01-01 12:25:22 UTC Re: [CAD_CAM_EDM_DRO] Gecko 320 with external encoder power supply Mariss Freimanis 2004-01-01 13:07:13 UTC Re: Gecko 320 with external encoder power supply wayne_j_hill 2004-01-01 16:05:04 UTC Re: Gecko 320 with external encoder power supply Jon Elson 2004-01-01 19:33:36 UTC Re: [CAD_CAM_EDM_DRO] Gecko 320 with external encoder power supply andrebarclay 2004-01-01 20:18:30 UTC Re: Gecko 320 with external encoder power supply