Re: Galil controllers compatible softwares
Posted by
jjmefoam
on 2004-01-18 08:20:39 UTC
Is there a link to the JRA systems.
EZ
--- In CAD_CAM_EDM_DRO@yahoogroups.com, Peter Renolds
<prenolds@s...> wrote:
EZ
--- In CAD_CAM_EDM_DRO@yahoogroups.com, Peter Renolds
<prenolds@s...> wrote:
> Have you looked at the two leads I gave you back on the 9th ofJan? I'm
> not aware of any other retrofit type systems based on Galil cards,but
> they may be out there. Just becasue you have the Galil card, youmay
> still want to consider the parallel port control options such asMach2
> and others discussed regularly on this list.selecting the
>
> From my research before buying and my satisfaction after
> JRA system I don't think you will get a better bang for your buckthan
> with the JRA system, assuming you already have the (expensive)Galil
> card. You can pick up AMC analog drives cheaply on eBay,typically
> around $120 - $130 per axis. FYI, I don't think there are manypeople
> on this list that use a Galil based controller for their CNCprojects.
>did and
> Contact the vendors and ask them for references - that's what I
> it was very enlightening. In the end, you have to decide whichcontrol
> best meets your needs and budget.softwares, which one
>
> Cheers, Peter
>
> Mouss_T wrote:
>
> > I need opinions about Galil controllers compatible
> >is good or
> >
> > is there enough alternative to choose.
> >
> >
> >
Discussion Thread
Mouss_T
2004-01-17 06:05:13 UTC
Galil controllers compatible softwares
tommy clay
2004-01-17 07:32:31 UTC
Re: [CAD_CAM_EDM_DRO] Galil controllers compatible softwares
Peter Renolds
2004-01-17 10:58:29 UTC
Re: [CAD_CAM_EDM_DRO] Galil controllers compatible softwares
jdmullett
2004-01-17 12:31:35 UTC
Re: Galil controllers compatible softwares
Shawncd
2004-01-17 12:41:10 UTC
Re: [CAD_CAM_EDM_DRO] Galil controllers compatible softwares
John Johnson
2004-01-17 17:26:10 UTC
Re: [CAD_CAM_EDM_DRO] Galil controllers compatible softwares
jjmefoam
2004-01-18 08:20:39 UTC
Re: Galil controllers compatible softwares
Peter Renolds
2004-01-18 11:33:50 UTC
Re: [CAD_CAM_EDM_DRO] Re: Galil controllers compatible softwares