RE: [CAD_CAM_EDM_DRO] replacing anilam crusader II control
Posted by
Larry Ragan
on 2004-02-16 11:11:38 UTC
I have done just that. I am using Mach2 for the control program and
Rutex servo drivers. It has been a process getting everything together
but I am getting close now. I used the original servo motors and the
anilam encoders. I removed the drive boards and replaced them with the
Rutex R990 servo drivers. I have also used the Geko drives but the 80V
limitation did not match up well with the 95V being supplied with the
Anilam power supply. Mach2 adds a lot of capabilities to the system. I
converted the z axis from the quill to the knee. At this point I have
some noise issues but I think they can be worked out with a little time.
Contact me off list if you would like more details.
Larry Ragan
Rutex servo drivers. It has been a process getting everything together
but I am getting close now. I used the original servo motors and the
anilam encoders. I removed the drive boards and replaced them with the
Rutex R990 servo drivers. I have also used the Geko drives but the 80V
limitation did not match up well with the 95V being supplied with the
Anilam power supply. Mach2 adds a lot of capabilities to the system. I
converted the z axis from the quill to the knee. At this point I have
some noise issues but I think they can be worked out with a little time.
Contact me off list if you would like more details.
Larry Ragan
Discussion Thread
Jim H
2004-02-16 10:52:22 UTC
replacing anilam crusader II control
Larry Ragan
2004-02-16 11:11:38 UTC
RE: [CAD_CAM_EDM_DRO] replacing anilam crusader II control
Roy J. Tellason
2004-02-16 12:34:20 UTC
Re: [CAD_CAM_EDM_DRO] replacing anilam crusader II control
Jim H
2004-02-18 18:50:46 UTC
Re: replacing anilam crusader II control
Jim H
2004-02-18 18:50:51 UTC
Re: replacing anilam crusader II control
Roy J. Tellason
2004-02-18 21:14:18 UTC
Re: [CAD_CAM_EDM_DRO] Re: replacing anilam crusader II control
Larry Ragan
2004-02-19 08:20:02 UTC
RE: [CAD_CAM_EDM_DRO] Re: replacing anilam crusader II control
Jim H
2004-02-20 18:50:39 UTC
Re: replacing anilam crusader II control
Roy J. Tellason
2004-02-20 20:45:33 UTC
Re: [CAD_CAM_EDM_DRO] Re: replacing anilam crusader II control
Jim H
2004-02-22 22:00:59 UTC
Re: replacing anilam crusader II control
Roy J. Tellason
2004-02-23 11:13:49 UTC
Re: [CAD_CAM_EDM_DRO] Re: replacing anilam crusader II control
metlmunchr
2004-02-23 11:58:27 UTC
Re: replacing anilam crusader II control
Jim H
2004-02-24 07:13:50 UTC
Re: replacing anilam crusader II control
Jim H
2004-02-25 07:46:23 UTC
Re: replacing anilam crusader II control
Harvey White
2004-02-25 08:48:45 UTC
Re: [CAD_CAM_EDM_DRO] Re: replacing anilam crusader II control
metlmunchr
2004-02-25 13:29:58 UTC
Re: replacing anilam crusader II control