Screen says "in motion", yet motors are not turning????

About a year ago I had my mill operating using TurboCNC (for a week)
(Camtronics power supply<servo>, Gecko drivers)
I took the machine apart and I am now getting to putting it together again.

Tonight I plugged everything in again and tried to Jog the motors.

On the screen that shows the readout or position of the servo for a particular axis, I can enter a postion, hit "G"(go)/"Y"(yes) and I get a "compensating" then a "in motion" instead of the numbers, yet the motor does not turn.

I have voltage to the motor(s), and the correct signals to the encoders(????)

Thanks