CAD CAM EDM DRO - Yahoo Group Archive

Re: Screen says "in motion", yet motors are not turning????

Posted by notoneleft
on 2004-02-23 21:52:57 UTC
Make sure you have the right port selected.

Gerry

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Mike Mueller"
<mueller914@y...> wrote:
> >> Do you have the err/reset pin tied to encoder + ? Some of the
> older
> > Gecko's would not move until you took the err/reset high for 5
sec.
>
>
> Not too sure, it worked fine last year, nothing was changed. All I
> did was power off everything and unplug it all. I'm now trying to
> find my documentation and go back thru everything.
>
> thanks

Discussion Thread

Mike Mueller 2004-02-23 08:34:59 UTC Screen says "in motion", yet motors are not turning???? caudlet 2004-02-23 12:56:56 UTC Re: Screen says "in motion", yet motors are not turning???? Mike Mueller 2004-02-23 16:56:00 UTC Re: Screen says "in motion", yet motors are not turning???? notoneleft 2004-02-23 21:52:57 UTC Re: Screen says "in motion", yet motors are not turning???? Mike Mueller 2004-02-25 16:07:19 UTC problem solved....=Re: Screen says "in motion", yet motors are not turning? Brian 2004-02-25 16:32:21 UTC Re: [CAD_CAM_EDM_DRO] problem solved....=Re: Screen says "in motion", yet motors are not turning? Harvey White 2004-02-25 17:30:04 UTC Re: [CAD_CAM_EDM_DRO] problem solved....=Re: Screen says "in motion", yet motors are not turning? xlch58@s... 2004-02-25 17:38:11 UTC Re: [CAD_CAM_EDM_DRO] problem solved....=Re: Screen says "in motion", yet motors are not turning?