Re: Screen says "in motion", yet motors are not turning????

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Mike Mueller"
<mueller914@y...> wrote:

>
> About a year ago I had my mill operating using TurboCNC (for a week)
> (Camtronics power supply<servo>, Gecko drivers)
> I took the machine apart and I am now getting to putting it

together again.

>
> Tonight I plugged everything in again and tried to Jog the motors.
>
> On the screen that shows the readout or position of the servo for a

particular axis, I can enter a postion, hit "G"(go)/"Y"(yes) and I
get a "compensating" then a "in motion" instead of the numbers, yet
the motor does not turn.

>
> I have voltage to the motor(s), and the correct signals to the

encoders(????)

>
> Thanks

Do you have the err/reset pin tied to encoder + ? Some of the older
Gecko's would not move until you took the err/reset high for 5 sec.