Re: Re: Tool Comp G41,G42

From: "Damon" <damonfg@...>

> Subject: Re: Tool Comp G41,G42
>
> The G41/42 in EMC is great.
>
> But I remeber getting burnt once, edited the tool table, ran the
> part and it didn't recognize the new tool. The finish cut was
> supposed to be offset for a 3/4" EM, but it took the old data
> for a 1/2" EM.
>
> I am now super cautious about editing the tool table while it's live,
> I'm more likely to load a couple of slots with similar tools so I
> can swap to any one of five 1/2" EMs, all predefined.

Sounds like about 2.16 or so of the bdi. We had a bug then that didn't
display all of the error messges like that. The newest gui, mini, has a
scratch pad area where error and other messages are displayed.

Ray