Re: [CAD_CAM_EDM_DRO] Re: How close can the wires be ? - Advice needed.
Posted by
Steven Ciciora
on 2004-03-06 16:07:48 UTC
How do you tell which revision drive you have? Both for stepper, and servo,
if you don't mind answering...
Thanks!
- Steven Ciciora
if you don't mind answering...
Thanks!
- Steven Ciciora
>Jeff,
>
>If you shield is grounded at the drive end only and if you are using
>our G320 REV7 drives, feel free to bundle them in a common harness.
>
>Mariss
Discussion Thread
ja_erickson
2004-03-06 13:54:08 UTC
How close can the wires be ? - Advice needed.
Roy J. Tellason
2004-03-06 15:14:31 UTC
Re: [CAD_CAM_EDM_DRO] How close can the wires be ? - Advice needed.
industrialhobbies
2004-03-06 15:40:38 UTC
Re: How close can the wires be ? - Advice needed.
Mariss Freimanis
2004-03-06 15:42:37 UTC
Re: How close can the wires be ? - Advice needed.
Steven Ciciora
2004-03-06 16:07:48 UTC
Re: [CAD_CAM_EDM_DRO] Re: How close can the wires be ? - Advice needed.
Mariss Freimanis
2004-03-06 17:49:21 UTC
Re: How close can the wires be ? - Advice needed.
Jon Elson
2004-03-06 21:40:54 UTC
Re: [CAD_CAM_EDM_DRO] How close can the wires be ? - Advice needed.
Michael Gamber
2004-03-07 17:58:12 UTC
Re: How close can the wires be ? - Advice needed.
Mariss Freimanis
2004-03-07 18:24:24 UTC
Re: How close can the wires be ? - Advice needed.
Michael Gamber
2004-03-08 08:07:27 UTC
Re: How close can the wires be ? - Advice needed.
Mariss Freimanis
2004-03-08 09:49:39 UTC
Re: How close can the wires be ? - Advice needed.
Michael Gamber
2004-03-08 17:28:41 UTC
Re: How close can the wires be ? - Advice needed.