Re: [CAD_CAM_EDM_DRO] Re: servomotor suitability???

Jon, that was my first thought too, then again I'm running 850w ac
servos on my table. anybody have any
leads on good motors to use on a router?

erie

Jon Elson wrote:

>>--- In CAD_CAM_EDM_DRO@yahoogroups.com, Erie Patsellis <erie@s...>
>>wrote:
>>
>>
>>
>>
>>>has anyone looked at *C&H surpus #DCME9850???*
>>>
>>>**
>>>
>>>
>>>
>>>
>Well, this is pretty iffy for a 200 Lb gantry. It is rated at 9.1
>Oz-In/Amp,
>with a 6.6 A rating listed. The peak current might be higher, I don't
>know. But, 6.6 A * 9.1 is only 60 Oz-In. That seems too small for the
>peak rating, though. The very low rotor inertial suggests this is probably
>an ironless rotor motor. Not a good match for driving heavy machinery,
>more likely for moving tape in a tape drive.
>
>Jon
>
>
>
>Addresses:
>FAQ: http://www.ktmarketing.com/faq.html
>FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
>Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
>List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@..., timg@...
>Moderator: pentam@... indigo_red@... davemucha@... [Moderators]
>URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
>OFF Topic POSTS: General Machining
>If you wish to post on unlimited OT subjects goto: aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if you have trouble.
>http://www.metalworking.com/news_servers.html
>
>http://groups.yahoo.com/group/jobshophomeshop I consider this to be a sister site to the CCED group, as many of the same members are there, for OT subjects, that are not allowed on the CCED list.
>
>NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM. DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
>bill
>List Mom
>List Owner
>
>
>Yahoo! Groups Links
>
>
>
>
>
>
>
>