RE: [CAD_CAM_EDM_DRO] Which version of EMC?

Dan,

What is the problem you are having with the Tkemc front-end? While I haven't
used it extensively it comes up and seems to run just fine.

Tim
[Denver, CO]

> -----Original Message-----
> From: Dan Falck [mailto:dfalck@...]
> Sent: Wednesday, April 19, 2000 4:37 PM
> To: CAD_CAM_EDM_DRO@egroups.com
> Subject: Re: [CAD_CAM_EDM_DRO] Which version of EMC?
>
>
> At 02:29 PM 4/19/00 -0500, you wrote:
>
> >Is anyone else running the 15Mar2000 version of EMC with Red Hat 5.2
> >(2.0.36 Kernel)
> >and XFree86? I had 2 hangups in one day with this, and went back to the
> >20Dec1999
> >version, which has never hung up. I've been running EMC reliably since
> >about June 1999,
> >and have not had any hangups since that time. (There were problems in
> >the XFree86
> >version for RH 5.0 that caused these problems.)
> >
> >If nobody else has had this kind of trouble with the 15Mar2000 version,
> >then I must have
> >done something wrong, maybe in the .ini file.
> >
> >Thanks,
> >
> >Jon
>
>
> Jon,
> It's not just you. I can't get the Tkemc gui to run under the Mar 15
> version. Xemc runs fine, but I would like to have the Tk gui because it's
> easy to alter.
>
> Dan