Re: [CAD_CAM_EDM_DRO] Which version of EMC?
Posted by
Jon Elson
on 2000-04-19 22:18:09 UTC
Tim Goldstein wrote:
and I believe
I used TkEMC before that, too. It worked fine! When I loaded the
15Mar2000 version,
it almost immediately hung up the GUI after jogging around for 15
seconds. I killed
EMC and restarted it, and it worked OK for several hours, and then
locked up such
that I couldn't even kill XFree86 with ctrl/alt/backspace. I had to hit
the reset button
(although I now know there are a couple of other ways in). I'm back to
20DEC1999,
and am having no problem with it.
I noticed later that somebody said the period command should not be in
the .ini file when using
steppermod. Would this also cause trouble with a servo system? This is
the only thing
that I can think of being different.
Jon
> Dan,I used TkEMC almost exclusively since I loaded the 20DEC1999 version,
>
> What is the problem you are having with the Tkemc front-end? While I
> haven't
> used it extensively it comes up and seems to run just fine.
and I believe
I used TkEMC before that, too. It worked fine! When I loaded the
15Mar2000 version,
it almost immediately hung up the GUI after jogging around for 15
seconds. I killed
EMC and restarted it, and it worked OK for several hours, and then
locked up such
that I couldn't even kill XFree86 with ctrl/alt/backspace. I had to hit
the reset button
(although I now know there are a couple of other ways in). I'm back to
20DEC1999,
and am having no problem with it.
I noticed later that somebody said the period command should not be in
the .ini file when using
steppermod. Would this also cause trouble with a servo system? This is
the only thing
that I can think of being different.
Jon
Discussion Thread
Jon Elson
2000-04-19 12:24:50 UTC
Re: [CAD_CAM_EDM_DRO] Which version of EMC?
Jon Elson
2000-04-19 12:29:20 UTC
Re: [CAD_CAM_EDM_DRO] Which version of EMC?
William Scalione
2000-04-19 16:32:46 UTC
Re: [CAD_CAM_EDM_DRO] Which version of EMC?
Dan Falck
2000-04-19 18:03:58 UTC
Re: [CAD_CAM_EDM_DRO] Which version of EMC?
Tim Goldstein
2000-04-19 19:53:19 UTC
RE: [CAD_CAM_EDM_DRO] Which version of EMC?
Jon Elson
2000-04-19 22:04:40 UTC
Re: [CAD_CAM_EDM_DRO] Which version of EMC?
Jon Elson
2000-04-19 22:11:09 UTC
Re: [CAD_CAM_EDM_DRO] Which version of EMC?
Jon Elson
2000-04-19 22:18:09 UTC
Re: [CAD_CAM_EDM_DRO] Which version of EMC?
Dan Falck
2000-04-21 07:55:48 UTC
RE: [CAD_CAM_EDM_DRO] Which version of EMC?