Re: [CAD_CAM_EDM_DRO] Which version of EMC?

Tim Goldstein wrote:

> I have found the 15-Mar-2000 version to be much better than the
> December
> version for steppers. I think that Jon Elson is happier with the
> December
> version for his servo setup. It is not very hard to install the
> different
> versions (just make sure your .run and .ini for each version is
> saved). I
> would start with the most recent if you are looking to test with
> steppers.

Is anyone else running the 15Mar2000 version of EMC with Red Hat 5.2
(2.0.36 Kernel)
and XFree86? I had 2 hangups in one day with this, and went back to the
20Dec1999
version, which has never hung up. I've been running EMC reliably since
about June 1999,
and have not had any hangups since that time. (There were problems in
the XFree86
version for RH 5.0 that caused these problems.)

If nobody else has had this kind of trouble with the 15Mar2000 version,
then I must have
done something wrong, maybe in the .ini file.

Thanks,

Jon