Re: [CAD_CAM_EDM_DRO] Re: Plasma Table-No Chain
Posted by
Vance Buhler
on 2000-04-24 20:12:55 UTC
-----Original Message-----
From: Steve Carlisle
Check out www.Torchmate.com for some ideas. I'm still racking my brain to beat simplicity and economy of this one. Vance Buhler
[Non-text portions of this message have been removed]
From: Steve Carlisle
>I could not find a similar product in McMaster's online catalog.Correct and the Berg unit looks like it would be a good system, but unless you are going to have a very small Plasma cutter it's going to be pretty pricey. In fact I'd like to know just how much it is with a .5" X 4+ foot rack. Anything much over 3 feet is likely to have too much deflection to be usable, so go to 1" diameter ??
>If you are comparing Bergs product to a standard rack, then
>you forgot to include the cost of the linear rail. Bergs combines
>the two items.
Check out www.Torchmate.com for some ideas. I'm still racking my brain to beat simplicity and economy of this one. Vance Buhler
[Non-text portions of this message have been removed]
Discussion Thread
Steve Carlisle
2000-04-24 10:17:48 UTC
Re: [CAD_CAM_EDM_DRO] Re: Plasma Table-No Chain
Vance Buhler
2000-04-24 13:36:42 UTC
Re: [CAD_CAM_EDM_DRO] Re: Plasma Table-No Chain
Steve Carlisle
2000-04-24 14:05:25 UTC
Re: [CAD_CAM_EDM_DRO] Re: Plasma Table-No Chain
Vance Buhler
2000-04-24 20:12:55 UTC
Re: [CAD_CAM_EDM_DRO] Re: Plasma Table-No Chain
Steve Carlisle
2000-04-24 21:21:32 UTC
Re: [CAD_CAM_EDM_DRO] Re: Plasma Table-No Chain
Vance Buhler
2000-04-25 00:28:17 UTC
Re: [CAD_CAM_EDM_DRO] Re: Plasma Table-No Chain
diazden
2000-04-25 02:11:23 UTC
Re: [CAD_CAM_EDM_DRO] Re: Plasma Table-No Chain
baileys@k...
2000-04-25 05:03:24 UTC
Re: [CAD_CAM_EDM_DRO] Re: Plasma Table-No Chain
Steve Carlisle
2000-04-25 16:31:02 UTC
Re: [CAD_CAM_EDM_DRO] Re: Plasma Table-No Chain
Bryan Mumford
2000-04-25 19:37:51 UTC
What ratio to use for stepper motor drive?