Re: [CAD_CAM_EDM_DRO] Anyone Familiar with an MHP S-24 CNC
Posted by
Dennis Cartier
on 2004-08-02 19:56:45 UTC
Jon Elson wrote:
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&rd=1&item=3830145853
I am hoping it has encoders rather than some older technology.
route, but figured it would be prohibitively expensive. I only have
single phase available, so that would require a phase converter as well
right?
Thanks,
Dennis
>Yes, right here. Hard to see much from the pictures.
> Is the eBay listing still there, so we can see a picture of it?
>
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&rd=1&item=3830145853
>Yes, I am pretty sure they are servos. I am not sure about the encoders.
> Does it have servo motors? Does it have encoders or resolvers?
> These are the big questions to be answered.
I am hoping it has encoders rather than some older technology.
>Not sure about the voltage issue. I had considered the transformer/VFD
> First, check if it is a dual-voltage motor. If not, why don't you get a
> 480 V VFD and a
> 240:480 V transformer?
route, but figured it would be prohibitively expensive. I only have
single phase available, so that would require a phase converter as well
right?
Thanks,
Dennis
Discussion Thread
Dennis Cartier
2004-08-02 09:47:42 UTC
Anyone Familiar with an MHP S-24 CNC
Bob Muse
2004-08-02 14:25:22 UTC
Re: [CAD_CAM_EDM_DRO] Anyone Familiar with an MHP S-24 CNC
Jon Elson
2004-08-02 17:36:25 UTC
Re: [CAD_CAM_EDM_DRO] Anyone Familiar with an MHP S-24 CNC
Dennis Cartier
2004-08-02 19:56:45 UTC
Re: [CAD_CAM_EDM_DRO] Anyone Familiar with an MHP S-24 CNC
Jon Elson
2004-08-02 22:30:44 UTC
Re: [CAD_CAM_EDM_DRO] Anyone Familiar with an MHP S-24 CNC
m37grady
2004-08-03 14:14:28 UTC
Re: Anyone Familiar with an MHP S-24 CNC
Dennis Cartier
2004-08-03 16:15:17 UTC
Re: [CAD_CAM_EDM_DRO] Re: Anyone Familiar with an MHP S-24 CNC
Dennis Cartier
2004-08-03 17:26:52 UTC
Re: [CAD_CAM_EDM_DRO] Anyone Familiar with an MHP S-24 CNC
Jon Elson
2004-08-03 20:22:22 UTC
Re: [CAD_CAM_EDM_DRO] Anyone Familiar with an MHP S-24 CNC
Dennis Cartier
2004-08-05 02:51:32 UTC
Re: [CAD_CAM_EDM_DRO] Anyone Familiar with an MHP S-24 CNC
Jon Elson
2004-08-05 09:07:13 UTC
Re: [CAD_CAM_EDM_DRO] Anyone Familiar with an MHP S-24 CNC