CAD CAM EDM DRO - Yahoo Group Archive

Troubleshooting a BTR

Posted by vinnygenovese
on 2004-08-06 16:47:10 UTC
I am trying to bring an IKEGIA FX25-N / Fanuc 5T back to life. There is a BTR
that I am trying to bring online. Problem is I don't have any instructions or dip
switch settings. I uploaded a photo to http://radiantheat.com/UCM-BTR.jpg.
The board has a single LED , which seems to 'blink' when i send data, but it
seems no signal gets through to the Fanuc 5T. (or I am sending the wrong
commands). I googled and googled. It seems they are out of business. Any
hints on the dip switch's or other hints would be very welcome.


Vinny \

Discussion Thread

vinnygenovese 2004-08-06 16:47:10 UTC Troubleshooting a BTR Jon Elson 2004-08-06 22:25:46 UTC Re: [CAD_CAM_EDM_DRO] Troubleshooting a BTR Stephen Wille Padnos 2004-08-07 10:10:39 UTC Re: [CAD_CAM_EDM_DRO] Troubleshooting a BTR metlmunchr 2004-08-07 10:34:57 UTC Re: Troubleshooting a BTR Alan Marconett 2004-08-07 11:56:44 UTC Re: [CAD_CAM_EDM_DRO] Troubleshooting a BTR Roy J. Tellason 2004-08-07 12:13:45 UTC Re: [CAD_CAM_EDM_DRO] Troubleshooting a BTR Harvey White 2004-08-07 13:43:57 UTC Re: [CAD_CAM_EDM_DRO] Troubleshooting a BTR Roy J. Tellason 2004-08-07 14:02:00 UTC Re: [CAD_CAM_EDM_DRO] Troubleshooting a BTR Alan Marconett 2004-08-07 14:35:16 UTC Re: [CAD_CAM_EDM_DRO] Troubleshooting a BTR Stephen Wille Padnos 2004-08-07 14:39:54 UTC Re: [CAD_CAM_EDM_DRO] Troubleshooting a BTR Roy J. Tellason 2004-08-07 14:55:50 UTC Re: [CAD_CAM_EDM_DRO] Troubleshooting a BTR vinnygenovese 2004-08-08 12:22:46 UTC Re: Troubleshooting a BTR metlmunchr 2004-08-08 13:50:35 UTC Re: Troubleshooting a BTR Jon Elson 2004-08-08 14:22:20 UTC Re: [CAD_CAM_EDM_DRO] Re: Troubleshooting a BTR luvindaddy@y... 2004-08-09 13:34:36 UTC Re: Troubleshooting a BTR luvindaddy@y... 2004-08-10 06:34:17 UTC Gateway BTR ....... was Re: Troubleshooting a BTR