Re: [CAD_CAM_EDM_DRO] BP Power supply

T1 is in the lower right-hand side of the Power Equipment Enclosure (as
you're facing it). What you'd do is disconnect the 240 volt input lines,
and wrap them (to isolate/insulate them), then connect your 120 volt
line (preferrably adequately fused) to the primary side of T1. The big
x-former in the middle is the 3-phase unit. Before you zap yopurself,
send me a fax# off list, and I can maybe get you some visuals...

RayHex

rocketscientistnate wrote:

>
> I have found the bridge rectifiers, and the capacitors, but I'm not
> sure where to go from here. I believe I need to rewire a
> transformer from 110V to 55V. Is this the big one in the middle of
> the power cabinet? How do I go about doing this? Where are the caps
> hooked back in? Should the bridge rectifiers to be moved to the
> power cabinet and the control cabinet completely removed? I know
> some people like to put the pc and contol components back in there,
> but I'm going to set mine on a desk nearby. I guess what I'm really
> trying to ask is how many of the wires between the two cabinets need
> to be disconnected and pulled out?