CAD CAM EDM DRO - Yahoo Group Archive

Re: RE: Re: AC brushless motors

Posted by Stephan Kotze
on 2004-10-13 00:07:48 UTC
> Well, I looked this up in the Digi-Key catalog, and the
> "design board"
> or reference
> kit is US $999! Yikes! I don't know whether you are getting
> some serious software to go with this, or just the board and
> chips. I couldn't find a proce for the IRMC201 chip alone.
>
> Jon
Jon

I have a qoute sitting on my desk, The IRMCK201 @ 15USD and the IRAMX16UP60A
@30USD Minimum order quantities = 90 for both. I believe you do get some
development software with the development kit for tuning the drives to the
motors you are using

Stephan

Discussion Thread

Stephan Kotze 2004-10-07 01:48:30 UTC AC brushless motors josef wagner 2004-10-07 04:01:35 UTC Re: [CAD_CAM_EDM_DRO] AC brushless motors hihihi 2004-10-07 07:34:42 UTC Re: [CAD_CAM_EDM_DRO] AC brushless motors MateuszGoÿffffb3ÿffffb9bek 2004-10-11 07:29:18 UTC Re: [CAD_CAM_EDM_DRO] AC brushless motors Stephan Kotze 2004-10-12 00:32:51 UTC RE: Re: AC brushless motors Jon Elson 2004-10-12 09:16:28 UTC Re: [CAD_CAM_EDM_DRO] RE: Re: AC brushless motors Stephan Kotze 2004-10-13 00:07:48 UTC Re: RE: Re: AC brushless motors Chris Cain 2004-10-13 03:57:02 UTC RE: [CAD_CAM_EDM_DRO] Re: RE: Re: AC brushless motors Jon Elson 2004-10-13 08:15:16 UTC Re: [CAD_CAM_EDM_DRO] Re: RE: Re: AC brushless motors Eric Keller 2004-10-13 20:34:46 UTC Re: Re: RE: Re: AC brushless motors