Re: Here we go again - more trouble

I thought that the voltage reading across the open fuse holder
suggested a problem and did not know that that was normal. At any
rate, I disconnected the motor and still found the same voltage
reading across the open fuse holder. So at that point I reasoned
that there must be something wrong with the connector from the Gecko
and replaced it. Then the reading across the fuse holder went to
zero! However, this was done without the capacitor installed across
terminals 1 and 2. Does it seem possible that the connector could be
bad? I did not see any stray strands of wire and could not measure
any shorts between the terminals of the connector. Possibly the
capacitor in place makes a difference? I did replace the capacitor.

Thanks
Keith Clark