Re: Servos drivers + THC servo ?

> The THC I created is designed to work with MACH2 as the "logic" of
> the circuit. It assumes that you have full control from MACH2 of
> your Z axis with a stepper or step to servo controller. For the
> motor you listed, the 79 buck solution would be perfect. The

encoder

> from the servo is fed into the motor controller and used for
> postiional comparison.
>

My question is ...

"which is better, a stepper or servo on the Z for a THC'd unit.? "

Ballscrew, ACME ?

It seems that a servo would offer a lot of speed, but a stepper might
be stronger for slow speed steps.

Dave