Re: Thread milling
Posted by
metlmunchr
on 2004-12-08 15:53:14 UTC
Graham, can you beat that for a quick answer to your question? It
does work real well. I used a 3 flute tap because the core diameter
is larger than on a 4 flute, and the tool was plenty stiff when held
in a collet chuck as short as practical and yet long enough to reach
the bottom of the hole.
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Graham Stabler" <eexgs@n...>
wrote:
does work real well. I used a 3 flute tap because the core diameter
is larger than on a 4 flute, and the tool was plenty stiff when held
in a collet chuck as short as practical and yet long enough to reach
the bottom of the hole.
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Graham Stabler" <eexgs@n...>
wrote:
>
> Would it be possible to take a normal tap and grind away two of the
> sets of teeth and then add some relief to the teeth remaining to
> make cheap multi point thread mills for specific pitches? Perhaps
> using a metal filled epoxy to fill the flutes and stiffen the
> assembly.
>
> Graham
Discussion Thread
Bengt
2004-12-08 01:10:47 UTC
Thread milling?
Jon Elson
2004-12-08 10:41:16 UTC
Re: [CAD_CAM_EDM_DRO] Thread milling?
Tom Hubin
2004-12-08 11:17:59 UTC
Re: [CAD_CAM_EDM_DRO] Thread milling?
glee@i...
2004-12-08 12:36:16 UTC
Re: [CAD_CAM_EDM_DRO] Thread milling & DolphinPartmaster CAD/CAM
Bengt
2004-12-08 13:08:50 UTC
Re: Thread milling & DolphinPartmaster CAD/CAM
Robert Lyman
2004-12-08 13:32:18 UTC
Re: [CAD_CAM_EDM_DRO] Re: Thread milling & DolphinPartmaster CAD/CAM
Graham Stabler
2004-12-08 15:46:32 UTC
Re: Thread milling
metlmunchr
2004-12-08 15:47:57 UTC
Re: Thread milling & DolphinPartmaster CAD/CAM
metlmunchr
2004-12-08 15:53:14 UTC
Re: Thread milling
metlmunchr
2004-12-08 15:56:36 UTC
Re: Thread milling
R Rogers
2004-12-08 16:29:11 UTC
Re: [CAD_CAM_EDM_DRO] Re: Thread milling
Graham Stabler
2004-12-09 01:16:20 UTC
Re: Thread milling
Peter Renolds
2004-12-09 05:50:14 UTC
Re: [CAD_CAM_EDM_DRO] Re: Thread milling
Jon Anderson
2004-12-09 07:50:39 UTC
Re: [CAD_CAM_EDM_DRO] Re: Thread milling
Jon Elson
2004-12-09 10:08:03 UTC
Re: [CAD_CAM_EDM_DRO] Re: Thread milling