Re: [CAD_CAM_EDM_DRO] VEXTA STEPPER HELP

Bill, the following from a Vexta catalog,

6V, 0.85A, 52.8oz-in, 7.1 ohm/phase, 9 mh/phase,0.6 oz-in
rotor inertia. They look like nema 23's. putting an ohm meter
on the leads will tell you where the center taps on each phase
are.

Steve

----------
From: wanliker@...
To: CAD_CAM_EDM_DRO@egroups.com
Subject: [CAD_CAM_EDM_DRO] VEXTA STEPPER HELP
Date: Saturday, May 20, 2000 10:07 PM

I have 3 VEXTS PH265M-31 steppers, .9 degrees, 2 phase 6 volt, .85 amp.

Does anyone on the list have any information on these units, and are they
big
enough for a SHERLINE Mill, direct drive.

Any help would be greatly appreciated. Especially the specifications. And

the wiring diagram, 6 wire.
White, yellow, green, black, blue, and red. I have not put a meter to them

yet.
Thanks,
bill

------------------------------------------------------------------------
Sign up for the free zZounds.com newsletter for the latest and
greatest music gear savings, musician tips and hot contests.
http://click.egroups.com/1/3738/3/_/423600/_/958885633/
------------------------------------------------------------------------

Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.

Addresses:
Post message: CAD_CAM_EDM_DRO@egroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
Moderator: jmelson@... [Moderator]
URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
FAQ: http://www.ktmarketing.com/faq.html
bill,
List Manager