CAD CAM EDM DRO - Yahoo Group Archive

Re: Wanted: Servo Motors that interface to Gecko 320

Posted by Fred Smith
on 2005-01-01 11:36:40 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "shadi_salhab_78"
<salhab@m...> wrote:
>

> I wana ask you what is the reduction ratio of the timming belt you
> are using to get 120 IPM . The G320 does not have a step
multiplaier
> and no program can give you more than 45000 ppm , so I think the
120
> IPM is imposible with G320 specially on a bridgport ?!


DeskCNC will run at 125,000 steps per second in Windows and several
of the DOS based controllers will also run up to 75,000 or 100,000
steps per second.

Fred Smith - IMService
http://www.cadcamcadcam.com/hobby

Discussion Thread

Joel 2004-12-29 08:12:11 UTC Wanted: Servo Motors that interface to Gecko 320 turbulatordude 2004-12-29 18:54:55 UTC Re: Wanted: Servo Motors that interface to Gecko 320 R Rogers 2004-12-30 06:47:08 UTC Re: [CAD_CAM_EDM_DRO] Wanted: Servo Motors that interface to Gecko 320 John Meissner 2004-12-30 09:12:12 UTC Re: Wanted: Servo Motors that interface to Gecko 320-Ron R Rogers 2004-12-30 15:42:47 UTC Re: [CAD_CAM_EDM_DRO] Re: Wanted: Servo Motors that interface to Gecko 320-Ron Jon Elson 2004-12-30 18:44:23 UTC Re: [CAD_CAM_EDM_DRO] Re: Wanted: Servo Motors that interface to Gecko 320-Ron shadi_salhab_78 2005-01-01 09:57:55 UTC Re: Wanted: Servo Motors that interface to Gecko 320 vrsculptor 2005-01-01 11:09:16 UTC Re: Wanted: Servo Motors that interface to Gecko 320 Fred Smith 2005-01-01 11:36:40 UTC Re: Wanted: Servo Motors that interface to Gecko 320 John Guenther 2005-01-01 11:53:39 UTC RE: [CAD_CAM_EDM_DRO] Re: Wanted: Servo Motors that interface to Gecko 320 R Rogers 2005-01-01 12:20:05 UTC Re: [CAD_CAM_EDM_DRO] Re: Wanted: Servo Motors that interface to Gecko 320 Roy J. Tellason 2005-01-01 14:33:22 UTC Re: [CAD_CAM_EDM_DRO] Re: Wanted: Servo Motors that interface to Gecko 320