CAD CAM EDM DRO - Yahoo Group Archive

Re: Jeff's mill drill Timing pulley milling cutter

on 2005-02-09 12:55:01 UTC
> few sources where I got stuff
> (And MAN are timing-pulleys expensive...
> you'll see...)
>
> Regards,
> Abby


I sent a request to a custome milling cutter grinder guy to see how
much it would cost to get a milling cutter to make a belt grouve.
then it would be a matter of just turning the OD and milling the
slots.

There are different types of belts. many are trapoizoidal, and some
are rounded. If one was to use a rounded belt, it would be a matter
of drilling in the proper circle and then turning the OD.

But, it is an easy matter to spend a couple hundred bucks on pulleys
and belts.

I priced up a belt for an H drive. $35 for the belt and $28 for a 16
tooth pulley. yikes !

Dave

Discussion Thread

len_tikular 2005-02-09 05:49:33 UTC Jeff's mill drill turbulatordude 2005-02-09 08:15:56 UTC Re: Jeff's mill drill len_tikular 2005-02-09 11:38:10 UTC Re: Jeff's mill drill AbbyKatt 2005-02-09 12:10:26 UTC RE: [CAD_CAM_EDM_DRO] Re: Jeff's mill drill turbulatordude 2005-02-09 12:55:01 UTC Re: Jeff's mill drill Timing pulley milling cutter Alan Marconett 2005-02-09 13:45:44 UTC Re: [CAD_CAM_EDM_DRO] Re: Jeff's mill drill Timing pulley milling cutter cnc_4_me 2005-02-09 13:53:25 UTC Re: Jeff's mill drill Timing pulley milling cutter turbulatordude 2005-02-09 18:05:23 UTC Re: Jeff's mill drill Timing pulley milling cutter cnc_4_me 2005-02-09 22:44:03 UTC Re: Jeff's mill drill Timing pulley milling cutter Bruce Pigeon 2005-02-10 05:02:19 UTC Re: [CAD_CAM_EDM_DRO] Re: Jeff's mill drill Timing pulley milling cutter turbulatordude 2005-02-10 07:36:38 UTC re: Timing pulley milling cutter erie 2005-02-10 12:16:19 UTC Re: [CAD_CAM_EDM_DRO] Re: Jeff's mill drill Timing pulley milling cutter turbulatordude 2005-02-10 19:46:21 UTC Re: Timing pulley selection software cnc_4_me 2005-02-10 20:52:56 UTC Re: Timing pulley selection software