Re: anyone using jr-kerr servos
Posted by
andy@o...
on 2000-06-02 13:07:15 UTC
Ron - Take a look at www.jrkerr.com for the new CMC interface. The
board buffer wants a list of points, in encoder counts, where the
motor is supposed to servo to at time increments of 1/30, 1/60, or
1/120th of a second. As the points are reached you can add new points
to the end of the list. He also has a dll which will convert lines
and arc segments to a point list. Source included for the software
literate!
board buffer wants a list of points, in encoder counts, where the
motor is supposed to servo to at time increments of 1/30, 1/60, or
1/120th of a second. As the points are reached you can add new points
to the end of the list. He also has a dll which will convert lines
and arc segments to a point list. Source included for the software
literate!
--- In CAD_CAM_EDM_DRO@egroups.com, Ron Ginger <ginger@s...> wrote:
> Has anyone used these in the serial interfce mode for coordinated
move
> situtation? Like one on X and one on Y and wanting them to mill an
> angled line?
>
> Do you calculate the time of the longest move, then program both
servos
> to that move time before sending the go command?
>
> I want to use this kind of serial interface under the CPNC ssytem
runing
> in a windows environment.
>
> ron
Discussion Thread
andrew abken
2000-06-01 06:33:44 UTC
anyone using jr-kerr servos
Carlos Guillermo
2000-06-01 16:48:55 UTC
RE: [CAD_CAM_EDM_DRO] anyone using jr-kerr servos
Steve Carlisle
2000-06-01 16:55:37 UTC
Re: [CAD_CAM_EDM_DRO] anyone using jr-kerr servos
Andy Olney
2000-06-01 22:24:32 UTC
RE: [CAD_CAM_EDM_DRO] anyone using jr-kerr servos
Andy Olney
2000-06-01 22:25:09 UTC
RE: [CAD_CAM_EDM_DRO] anyone using jr-kerr servos
Dan Mauch
2000-06-02 07:36:49 UTC
Re: [CAD_CAM_EDM_DRO] anyone using jr-kerr servos
Ron Ginger
2000-06-02 08:16:50 UTC
Re: [CAD_CAM_EDM_DRO] anyone using jr-kerr servos
andy@o...
2000-06-02 13:07:15 UTC
Re: anyone using jr-kerr servos
andrew abken
2000-06-02 18:46:18 UTC
RE: [CAD_CAM_EDM_DRO] anyone using jr-kerr servos
andrew abken
2000-06-02 19:36:27 UTC
RE: [CAD_CAM_EDM_DRO] anyone using jr-kerr servos