Re: [CAD_CAM_EDM_DRO] Re: BANDIT controls - recommendations?
Posted by
Doug Fortune
on 2005-03-28 17:15:41 UTC
re: replacing the BANDIT driver with Gecko drivers
Doug wrote:
is a good speed to shoot for because slower than that might begin to
bug you after a while.
complications... if the extra complication is worth the extra top end
speed to you (and if the servos are not underpowered), then its hard to
go wrong with servos. I just like the steppers, because they are way
simpler, and when they are set up correctly, they'll match the servos
in every which way but top speed.
cheers
Doug Fortune
.
Doug wrote:
>>The existing steppers work awesome, you'd think it was a servo it isNo, 2 inch/sec is scarey fast enough for me on a mill, although that
>> so smooth (but being steppers, the top speed maxes out at 2 inch/sec
>> on each axis).
>2 in/sec is 120 ipm, sounds fairly fast to me. Do you find this to
>be a limiting factor?
is a good speed to shoot for because slower than that might begin to
bug you after a while.
>I am still on the fence about steppers or servos, i have both motorsI can't tell you, I like both! Servos are nice, but with additional
>sitting here, could use either one. Just need to buy drivers.
complications... if the extra complication is worth the extra top end
speed to you (and if the servos are not underpowered), then its hard to
go wrong with servos. I just like the steppers, because they are way
simpler, and when they are set up correctly, they'll match the servos
in every which way but top speed.
cheers
Doug Fortune
.
Discussion Thread
mpictor
2005-03-27 19:05:19 UTC
BANDIT controls - recommendations?
R Rogers
2005-03-27 19:50:08 UTC
Re: [CAD_CAM_EDM_DRO] BANDIT controls - recommendations?
Jon Elson
2005-03-27 21:39:34 UTC
Re: [CAD_CAM_EDM_DRO] BANDIT controls - recommendations?
Doug Fortune
2005-03-28 07:41:26 UTC
Re: BANDIT controls - recommendations?
mpictor
2005-03-28 10:32:51 UTC
Re: BANDIT controls - recommendations?
David A. Frantz
2005-03-28 13:18:25 UTC
Re: [CAD_CAM_EDM_DRO] BANDIT controls - recommendations?
cnc_4_me
2005-03-28 14:05:33 UTC
Re: BANDIT controls - recommendations?
R Rogers
2005-03-28 14:30:59 UTC
Re: [CAD_CAM_EDM_DRO] Re: BANDIT controls - recommendations?
Doug Fortune
2005-03-28 17:15:41 UTC
Re: [CAD_CAM_EDM_DRO] Re: BANDIT controls - recommendations?