RE: [CAD_CAM_EDM_DRO] EMC ,STG-II

Babar,

> You mean I should give G92.2 at the end of each
> program ? or in MDI before closing the software or
> system?

Neither. When you restart EMC. If G92 offsets were
in effect, this takes them out of effect. In the case where
the G92 offsets were NOT in effect before shutdown, this will
give you the same values you had. (this assumes you have 'homed'
your machine.)

> > It is a good idea to make sure G92 is off before
> > setting coordinate system
> > offsets, as well.
>
> Using MDI mode ?????

That's what I was thinking. Saves a bit of confusion at times.

> > You might also check to see what coordinate system
> > you were in before
> > exiting EMC. EMC boots to the value of .var file
> > variable #5220, 1-9
> > (G54-G59.3). If for some odd reason this was changed
> > to be different than
> > the last coordinate system, you may be in a
> > different coordinate system.
>
> These values are either 1 or 0 , should I cset this
> value #5220 each time before restarting the system?

#5220 must be an integer '1' through '9'. '0' is an invalid system number,
and guarantees problems.

> Will it also solve the problem of not supporting
> G54-G59?

G54-G59.3 are fully supported. (Perhaps I'm not understanding your question,
here?)

HTH,

Keith