Re: Axis enable problem
Posted by
sse_jimmy
on 2005-08-16 09:26:04 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, John Johnson <johnatl@m...> wrote:
exactly what i had in mind. I'm sure would appreciate it, if you
wouldn't minde to draw up a schematic.
Thanks again:
Jimmy
> Jimmy,Thank you very much John, for the quick response to my post. That is
>
> You could use a "one-shot" also known as a "mono-stable multivibrator".
> All that gibberish just means that when the circuit gets a pulse on the
> input, it sends a pulse out of some (longer) length. Any more pulses
> that
> arrive just keep reseting it. So what you do is, connect the step pulses
> from the axes into the one-shot. As long as you're stepping, the motors
> stay on. When you stop stepping for some period, the enable goes off.
>
> Like this:
>
> __ _ _ _ _ _
> x step___ __ _ _ _ _ ________________
>
> _______________________
> enable___ __________
>
> You can use a few discrete components (resistors, etc.) and a NE555
> timer chip to do this.
> I can cook up a schematic if you'd like.
>
> Regards,
> JJ
>
exactly what i had in mind. I'm sure would appreciate it, if you
wouldn't minde to draw up a schematic.
Thanks again:
Jimmy
Discussion Thread
sse_jimmy
2005-08-15 20:30:15 UTC
Axis enable problem
John Johnson
2005-08-16 06:40:39 UTC
Re: [CAD_CAM_EDM_DRO] Axis enable problem
Andrey Lipavsky
2005-08-16 07:16:25 UTC
RE: [CAD_CAM_EDM_DRO] Axis enable problem
sse_jimmy
2005-08-16 09:26:04 UTC
Re: Axis enable problem
Jon Elson
2005-08-16 09:41:23 UTC
Re: [CAD_CAM_EDM_DRO] Axis enable problem
John Johnson
2005-08-21 19:52:47 UTC
Re: [CAD_CAM_EDM_DRO] Axis enable problem