Re: skate bearings

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Randy Wink" <rwwink@i...> wrote:

> Allen heads are about .002 under nominal or in this case about .310 +/-.
> 8mm is .31496 so it looks like you'll have about .004 clearance.

You'd most

> likely do better to get an 8mm socket head that would be around .312
> diameter.
> R. Wink

OK,s I think I had them backwards.

if I use an 8mm bolt with a 5/16 bearing, it should be either a press
fit or one I can ground to fit.

I do understand the threads may be larger than the body. but That too
can be addressed in the project.

Dave