Re: [CAD_CAM_EDM_DRO] Help Needed, Ballscrews

Microkinetics has a ball screw conversion kit for knee mills. Try
www.microkinetics.com

Doug

----- Original Message -----
From: <wanliker@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Cc: <modeleng-list@...>
Sent: Friday, June 23, 2000 6:24 PM
Subject: [CAD_CAM_EDM_DRO] Help Needed, Ballscrews


> <<You could do some enquiries for me, as I have got no-where on the net.
> I am looking for Ball leadscrews for my miller. It is a Bridgeport
> look-alike. The X axis needs a 3/4" to 1" x 32" Ball-screw, plus
> flanged Ball-nut 2/10" lead. The Y axis is 15" long. I just require
> the threaded part as I'll make up my own ends. I would prefer the
> diameter nearer 3/4" than 1" as the ball-nut is larger than the acme
> nuts on the machine and it may be difficult to get them in. >>
>
> I just got the following note from a friend, can anyone on the list make a
> recommendation for a source of the pieces he needs. Also an URL would be
> greatly appreciated if possible.
> Thanks,
> bill
>
> ------------------------------------------------------------------------
> Was the salesman clueless? Productopia has the answers.
> http://click.egroups.com/1/4633/4/_/423600/_/961799106/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>