CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: PMDX-131 and Mach2

on 2005-11-10 10:13:48 UTC
On Thursday 10 November 2005 01:06 pm, Steve Stallings wrote:

> Also keep in mind that the PMDX-131 is for Gecko STEPPER motor drivers only.
> If you are using G320 or G340 drivers you cannot use the PMDX-131.

<...>

> The PMDX-122 is not as nice as the PMDX-131, but it can be used with
> either servo or stepper drivers.

Just curious, we're talking about breakout boards here? What would be
different between them that you could use one with either steppers or servos
and the other with steppers only?

--
Member of the toughest, meanest, deadliest, most unrelenting -- and
ablest -- form of life in this section of space, a critter that can
be killed but can't be tamed. --Robert A. Heinlein, "The Puppet Masters"

Discussion Thread

rocketscientistnate 2005-11-10 09:19:42 UTC PMDX-131 and Mach2 Steve Stallings 2005-11-10 10:06:49 UTC Re: PMDX-131 and Mach2 Roy J. Tellason 2005-11-10 10:13:48 UTC Re: [CAD_CAM_EDM_DRO] Re: PMDX-131 and Mach2 Steve Stallings 2005-11-10 10:22:15 UTC Re: PMDX-131 and Mach2 afogassa 2005-11-10 15:34:36 UTC Re: PMDX-131 and Mach2 rocketscientistnate 2005-11-12 09:53:59 UTC PMDX-131 and Mach2 R Rogers 2005-11-12 10:21:07 UTC Re: [CAD_CAM_EDM_DRO] PMDX-131 and Mach2 rocketscientistnate 2005-11-12 13:23:09 UTC Mach2 Fred Smith 2005-11-12 13:47:28 UTC Re: Mach2 Sorin Paul 2005-11-12 14:07:14 UTC Re: [CAD_CAM_EDM_DRO] Mach2