Re: [CAD_CAM_EDM_DRO] Maxnc - don't buy it!

Thanks, Bill, I will take you up on that. My phone number is 817-315-4261. I am a block off of Lake Arlington on the east side,
but I can transport the box up to the north end. BTW, we have to be careful, two American-Italians in the same room may constitute
a violation of the Rico statues, especially here in Texas.

Thanks,

Mike

William Scalione wrote:

> Mike;
>
> If you need a hand installing EMC let me know, I have done a couple,
> one RH 5.2 and one RH 6.0. No guarantees but we can try. BTW, I live
> about 1 mile from Bob Campbell. You will need about a 1 Gig hard drive.
> I don't think splitting a drive with windows or dos is the way to go
> though.
>
> Bill
>
> ------------------------------------------------------------------------
> Accurate impartial advice on everything from laptops to table saws.
> http://click.egroups.com/1/4634/4/_/423600/_/962781062/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager