Re: [CAD_CAM_EDM_DRO] Re: USBCNC was PICstep
Posted by
Wayne Weedon
on 2006-05-18 05:32:26 UTC
turbulatordude wrote:
I said Mach defaults to 25Khz, which is too slow for real servo
performance, but also would not max out most steppers.
Any product like that has to be able to get something close to the step
rates of say the G100 to be viable, especially for servo's. I cant say
the 4Mhz the G100 is apparently able to do is realistic, but certainly
250Khz is. The geckodrives are rated at least to that...
i/o and actually have some control over it.
--
---------------------------------------------------------------------------
Wayne M Weedon Email: wayne@...
Fdos Design Poole UK
Tel +44-1202-677025 Fax +44-1202-770515 Mobile: 07774 439915
Specialists in small batch & Production Mechanical/Electrical Engineering
---------------------------------------------------------------------------
>I noticed that too. Funny how that fact was just brushed aside ;) As
>
>
>>So what's wrong with http://www.usbcnc.com/ ? Again, everything goes
>>in the PIC code.
>>
>>
>
>Interesting product.
>
>first thing I see is the 25Khz as the listed top pulse rate.
>
>
I said Mach defaults to 25Khz, which is too slow for real servo
performance, but also would not max out most steppers.
Any product like that has to be able to get something close to the step
rates of say the G100 to be viable, especially for servo's. I cant say
the 4Mhz the G100 is apparently able to do is realistic, but certainly
250Khz is. The geckodrives are rated at least to that...
>I did not see any mention of a modbus support for external devices,Yes just as important. Not specifically Modbus but someway to expand
>but that has got to be a future addition and probably a second board.
> I think that if you are going serial, it would be a simple extention
>of the USB.
>
>
i/o and actually have some control over it.
--
---------------------------------------------------------------------------
Wayne M Weedon Email: wayne@...
Fdos Design Poole UK
Tel +44-1202-677025 Fax +44-1202-770515 Mobile: 07774 439915
Specialists in small batch & Production Mechanical/Electrical Engineering
---------------------------------------------------------------------------
Discussion Thread
Dennis Schmitz
2006-05-18 01:44:37 UTC
PICstep Was: Interface. Gauging interest.
Wayne Weedon
2006-05-18 03:45:28 UTC
Re: [CAD_CAM_EDM_DRO] PICstep Was: Interface. Gauging interest.
turbulatordude
2006-05-18 04:51:20 UTC
Re: USBCNC was PICstep
Dennis Schmitz
2006-05-18 04:55:25 UTC
Re: [CAD_CAM_EDM_DRO] PICstep Was: Interface. Gauging interest.
Wayne Weedon
2006-05-18 05:32:26 UTC
Re: [CAD_CAM_EDM_DRO] Re: USBCNC was PICstep
Steve Blackmore
2006-05-18 16:41:52 UTC
Re: [CAD_CAM_EDM_DRO] Re: USBCNC was PICstep
Mariss Freimanis
2006-05-19 06:27:28 UTC
Re: USBCNC was PICstep