Re: TurboCNC

Bill:

Active low on the step line for the Xylotex.

I'm not aware of any breakout board that does signal inversion on
outbound pulses, but I can't rule it out - there are a lot of guys
building these nowadays.

Have fun!

Dave Kowalczyk
Kent, WA
TurboCNC software --> http://www.dakeng.com/turbo.html

--- In CAD_CAM_EDM_DRO@yahoogroups.com, wanliker@... wrote:
>
> In TurboCNC settings, are the Step and Direction settings
supposed to
> be Logic High or Logic low, when used with the Xylotex drive?
> Does a opto isolator breakout board change this?
> Thanks,
> bill
>