Re: contact probes
Posted by
turbulatordude
on 2006-06-03 20:59:57 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "guzakaka" <nonna01@...> wrote:
the cutter will both cool and remove chips. for plastics, it is
important to get them out of the way. if the come in to get cut a
second time, they often wipe along the surface before shearing. that
wiping action heats things up and the chips melt. very messy.
Dave
>Try to evacuate the chips as agressivly as possible. an air hose on
> Hi Graham,
>
> Not linear but circular. I tried cutting fast but I found the
> circular cuts were not round. I tried pre-drilling and then
> taking .010" cuts, but at 22,000 rpm I still had plastic sticking to
> the bit. It is delrin btw. I slowed the feed down to as low as 10 ipm
> with the small cuts but still no good. Yesterday I tried some glass
> filled nylon and that was disaster! I have some phenolic impregnated
> wood laminate that I may try.
>
> Mike
the cutter will both cool and remove chips. for plastics, it is
important to get them out of the way. if the come in to get cut a
second time, they often wipe along the surface before shearing. that
wiping action heats things up and the chips melt. very messy.
Dave
Discussion Thread
Monte Milanuk
2006-06-02 08:14:19 UTC
contact probes
Alan Marconett
2006-06-02 08:52:31 UTC
RE: [CAD_CAM_EDM_DRO] contact probes
ballendo
2006-06-03 05:08:47 UTC
Re: contact probes
Graham Stabler
2006-06-03 06:44:05 UTC
Re: contact probes
guzakaka
2006-06-03 08:42:09 UTC
Re: contact probes
Graham Stabler
2006-06-03 10:35:51 UTC
Re: contact probes
guzakaka
2006-06-03 13:54:00 UTC
Re: contact probes
Graham Stabler
2006-06-03 15:10:31 UTC
Re: contact probes
BRIAN FOLEY
2006-06-03 15:16:50 UTC
Re: [CAD_CAM_EDM_DRO] Re: contact probes
wanliker@a...
2006-06-03 17:19:24 UTC
Re: [CAD_CAM_EDM_DRO] Re: contact probes
Graham Stabler
2006-06-03 17:32:49 UTC
Re: contact probes
guzakaka
2006-06-03 20:15:10 UTC
Re: contact probes
guzakaka
2006-06-03 20:19:38 UTC
Re: contact probes
turbulatordude
2006-06-03 20:59:57 UTC
Re: contact probes
Graham Stabler
2006-06-04 09:59:28 UTC
Re: contact probes