Re: [CAD_CAM_EDM_DRO] purpose of the group

I sent a message about a week ago and it never did appear on my computer,but
going by another message from someone else I think other people got it.
Larry Ruebush

----- Original Message -----
From: "james owens" <wotisname@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Sunday, July 09, 2000 1:18 PM
Subject: Re: [CAD_CAM_EDM_DRO] purpose of the group


> Hi All,
>
> I hate to have to say it but I agree with Tim :-)
>
> I posted several replies and none have bounced back in the list as they
usually do. I did however check http://www.egroups.com/group/CAD_CAM_EDM_DRO
and they have appeared. I assumed that the rest of the list saw them and it
was my end that was the problem.
>
> Regards,
>
> Terry
>
> ----- Original Message -----
> From: Tim Goldstein
> To: CAD_CAM_EDM_DRO@egroups.com
> Sent: Sunday, July 09, 2000 5:30 PM
> Subject: RE: [CAD_CAM_EDM_DRO] purpose of the group
>
>
> As far as I can tell this group does not have it's messages reviewed
before
> posting. There have been some pretty controversial discussions and ones
that
> needed Bill to step in and quench the flames, but I have never seen Bill
> censor messages.
>
> Tim
> [Denver, CO]
>
> P.S. I sent this reply last night at 12:47 am mountain time and it never
> appeared so I am reposting it. Looks like lost postings are happening to
> many of us at the moment.
>
> > Bill
> >
> > Recently I have made posts to this group that have not showed up after
I
> > posted them. These posts all had one thing in common; controversy. Do
you
> > censor what is posted here?/mac
> > List Manager
>
>
>
> [Non-text portions of this message have been removed]
>
>
> ------------------------------------------------------------------------
> Free Conference Calling with Firetalk!
> Click Here!
> http://click.egroups.com/1/5480/4/_/423600/_/963166742/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>