Re: [CAD_CAM_EDM_DRO] Re: Gecko servos
Posted by
james owens
on 2000-07-15 15:04:57 UTC
Thanks Tim,
It seems that I bought the wrong ones for the purpose I intended them for, but that was before the Gecko drives were announced. I'll just have to order the right ones next time.
The G9932 must be the 400 slot encoders.
The G9933 must be the 1000 slot because they have the larger housings.
Regards,
Terry
It seems that I bought the wrong ones for the purpose I intended them for, but that was before the Gecko drives were announced. I'll just have to order the right ones next time.
The G9932 must be the 400 slot encoders.
The G9933 must be the 1000 slot because they have the larger housings.
Regards,
Terry
----- Original Message -----
From: Tim Goldstein
To: CAD_CAM_EDM_DRO@egroups.com
Sent: Saturday, July 15, 2000 4:09 AM
Subject: RE: [CAD_CAM_EDM_DRO] Re: Gecko servos
I actually have both. One has a 1000 slot disk and the other has a 400 slot
disk. I don't know which is which as their online catalog is hosed if you
try to use the category lookup and go to motors or do a search. I have
e-mailed them for a week about the online catalog and even called them
today. I was put on hold for 15 minutes and finally hung up. I can't find my
printed catalog either to give you the part number. If you look in the
picture you will see one has an encoder housing that is the same diameter as
the motor, that is the 400 slot disk unit. The one with the big encoder
housing is the 1000 slot disk unit.
Which one to get depends upon your application. For a DRO you want the 1000
slot, for the Geckodrives servos it seems like the 400 slot works better
unless your computer can put out a HUGE amount of pulses.
Tim
[Denver, CO]
[Non-text portions of this message have been removed]
Discussion Thread
james owens
2000-07-14 17:54:48 UTC
Re: [CAD_CAM_EDM_DRO] Re: Gecko servos
Tim Goldstein
2000-07-14 20:09:57 UTC
RE: [CAD_CAM_EDM_DRO] Re: Gecko servos
james owens
2000-07-15 15:04:57 UTC
Re: [CAD_CAM_EDM_DRO] Re: Gecko servos
Alvaro Fogassa
2000-07-15 18:09:18 UTC
Re: Gecko servos
Tim Goldstein
2000-07-15 20:00:35 UTC
RE: [CAD_CAM_EDM_DRO] Re: Gecko servos
Carlos Guillermo
2000-07-15 20:32:29 UTC
300 IPM - machine resolution and encoder slots
Alvaro Fogassa
2000-07-15 20:32:58 UTC
Re: Gecko servos
Alvaro Fogassa
2000-07-15 20:51:59 UTC
Re: 300 IPM - machine resolution and encoder slots
Tim Goldstein
2000-07-15 22:03:09 UTC
RE: [CAD_CAM_EDM_DRO] Re: Gecko servos
Carlos Guillermo
2000-07-16 07:31:24 UTC
RE: [CAD_CAM_EDM_DRO] Re: 300 IPM - machine resolution and encoder slots
Doug Harrison
2000-07-16 09:11:39 UTC
Re: [CAD_CAM_EDM_DRO] Re: 300 IPM - machine resolution and encoder slots