Re: Power draw bar
Posted by
Ron Ginger
on 2006-12-21 09:32:12 UTC
I have just started a power drawbar for the Jet knee mill Im doing. I
ordered a 1/2" drive electric impact wrench from Homier for $30. Im
going to mount it on parallel bars to slide up and down, with a spring
to hold it up. I plan to operate the thing manually- just reach up, grab
the body of the wrench, pull it down against the springs while pressing
the forward or revers button. I think this will be much simpler than all
the air hoses and cylinders.
Ill put some photos up when I get it together- should be in a couple
more days.
ron ginger
ordered a 1/2" drive electric impact wrench from Homier for $30. Im
going to mount it on parallel bars to slide up and down, with a spring
to hold it up. I plan to operate the thing manually- just reach up, grab
the body of the wrench, pull it down against the springs while pressing
the forward or revers button. I think this will be much simpler than all
the air hoses and cylinders.
Ill put some photos up when I get it together- should be in a couple
more days.
ron ginger
Discussion Thread
Vince Endter
2006-12-20 15:02:33 UTC
Power draw bar
Mark Vaughan
2006-12-20 15:20:33 UTC
RE: [CAD_CAM_EDM_DRO] Power draw bar
BRIAN FOLEY
2006-12-20 15:34:05 UTC
Re: [CAD_CAM_EDM_DRO] Power draw bar
Ron Ginger
2006-12-21 09:32:12 UTC
Re: Power draw bar
HTCLKI@A...
2006-12-28 11:58:41 UTC
Re: [CAD_CAM_EDM_DRO] Re: Power draw bar
Mark Vaughan
2006-12-28 17:50:51 UTC
RE: [CAD_CAM_EDM_DRO] Re: Power draw bar
Larry Van Duyn
2006-12-28 18:15:18 UTC
Re: [CAD_CAM_EDM_DRO] Re: Power draw bar
George Taylor, IV
2006-12-28 20:31:10 UTC
RE: [CAD_CAM_EDM_DRO] Re: Power draw bar
Mark Vaughan
2006-12-29 02:38:17 UTC
RE: [CAD_CAM_EDM_DRO] Re: Power draw bar
Polaraligned
2006-12-29 04:50:12 UTC
Re: Power draw bar
Vince Endter
2007-01-03 18:51:37 UTC
Power draw bar
BRIAN FOLEY
2007-01-03 20:01:45 UTC
Re: [CAD_CAM_EDM_DRO] Power draw bar
George Taylor, IV
2007-01-03 22:06:26 UTC
RE: [CAD_CAM_EDM_DRO] Power draw bar
Vince Endter
2007-01-04 06:17:19 UTC
Re: Power draw bar
George Taylor, IV
2007-01-04 20:30:34 UTC
RE: [CAD_CAM_EDM_DRO] Re: Power draw bar
kiwiavi
2007-01-06 02:09:43 UTC
Re: Power draw bar