Re: Power draw bar
Posted by
Vince Endter
on 2007-01-04 06:17:19 UTC
The bridge is a 3"x6.5"x3/8" piece held off the top of the mill by a
couple of aluminum blocks. The mechanism is just a 3/8" butterfly
impact wrench. I took the rear valve off and mounted it on a separate
plate. I disposed of the butterfly lever and made another lever that
would work from the front.
Vince
couple of aluminum blocks. The mechanism is just a 3/8" butterfly
impact wrench. I took the rear valve off and mounted it on a separate
plate. I disposed of the butterfly lever and made another lever that
would work from the front.
Vince
> What did you build
> for the bridge across the range lever at the top of the head, and how
> did you build the pneumatic reversing switch?
>
Discussion Thread
Vince Endter
2006-12-20 15:02:33 UTC
Power draw bar
Mark Vaughan
2006-12-20 15:20:33 UTC
RE: [CAD_CAM_EDM_DRO] Power draw bar
BRIAN FOLEY
2006-12-20 15:34:05 UTC
Re: [CAD_CAM_EDM_DRO] Power draw bar
Ron Ginger
2006-12-21 09:32:12 UTC
Re: Power draw bar
HTCLKI@A...
2006-12-28 11:58:41 UTC
Re: [CAD_CAM_EDM_DRO] Re: Power draw bar
Mark Vaughan
2006-12-28 17:50:51 UTC
RE: [CAD_CAM_EDM_DRO] Re: Power draw bar
Larry Van Duyn
2006-12-28 18:15:18 UTC
Re: [CAD_CAM_EDM_DRO] Re: Power draw bar
George Taylor, IV
2006-12-28 20:31:10 UTC
RE: [CAD_CAM_EDM_DRO] Re: Power draw bar
Mark Vaughan
2006-12-29 02:38:17 UTC
RE: [CAD_CAM_EDM_DRO] Re: Power draw bar
Polaraligned
2006-12-29 04:50:12 UTC
Re: Power draw bar
Vince Endter
2007-01-03 18:51:37 UTC
Power draw bar
BRIAN FOLEY
2007-01-03 20:01:45 UTC
Re: [CAD_CAM_EDM_DRO] Power draw bar
George Taylor, IV
2007-01-03 22:06:26 UTC
RE: [CAD_CAM_EDM_DRO] Power draw bar
Vince Endter
2007-01-04 06:17:19 UTC
Re: Power draw bar
George Taylor, IV
2007-01-04 20:30:34 UTC
RE: [CAD_CAM_EDM_DRO] Re: Power draw bar
kiwiavi
2007-01-06 02:09:43 UTC
Re: Power draw bar