Slo Syn 3 wire motor
Posted by
pgb_za
on 2007-05-10 07:01:59 UTC
Hi All,
I have a slo-syn motor rated at ss250, 250 oz-in, 0.6A, 120V.
The motor has only 3 wires but can be converted to uni or bipolar by
following the instructions given by Paul Jones www.cnconabudget.com.
I want to use the motor to build a dividing head but also learn how to
drive a stepper motor. Ultimately going on to convert my mill.
As a ambitious newbie I would appreciate any help or guidance on
sourcing a suitable driver circuit that I can build. I am in South
Africa so ready built boards or alternative motors are not readily
[inexpensively] available.
Kind regards
Paul
I have a slo-syn motor rated at ss250, 250 oz-in, 0.6A, 120V.
The motor has only 3 wires but can be converted to uni or bipolar by
following the instructions given by Paul Jones www.cnconabudget.com.
I want to use the motor to build a dividing head but also learn how to
drive a stepper motor. Ultimately going on to convert my mill.
As a ambitious newbie I would appreciate any help or guidance on
sourcing a suitable driver circuit that I can build. I am in South
Africa so ready built boards or alternative motors are not readily
[inexpensively] available.
Kind regards
Paul
Discussion Thread
pgb_za
2007-05-10 07:01:59 UTC
Slo Syn 3 wire motor
Alan KM6VV
2007-05-10 08:28:29 UTC
RE: [CAD_CAM_EDM_DRO] Slo Syn 3 wire motor
Bob Campbell
2007-05-10 08:54:14 UTC
Re: [CAD_CAM_EDM_DRO] Slo Syn 3 wire motor
ballendo
2007-05-10 18:36:24 UTC
Re: Slo Syn 3 wire motor
ballendo
2007-05-10 18:41:46 UTC
Re: Slo Syn 3 wire motor
Bob Campbell
2007-05-10 19:08:13 UTC
Re: [CAD_CAM_EDM_DRO] Re: Slo Syn 3 wire motor
pgb_za
2007-05-11 07:11:29 UTC
Slo Syn 3 wire motor
pb
2007-05-11 07:34:01 UTC
Re: Slo Syn 3 wire motor