Re: Newbie question on getting started

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "marcushmm" <marcushmm@...> wrote:

>
> This uses a Compumotor CX driver and some Compumotor stepper motors
> that unfortunatly have the model number worn off.
> Is there some other spot on the stepper that the voltage or specs
> would be stamped in?

The current limit for the motor may be set on the driver via a
resistor or similar, consulting the manual for the driver should get
you the current for the motor.

> From scanning the CX manual I think I will be able to figure out the
> basic specs of the motors from the jumper selection on the CX.

Ah yes you will :)

>
> Would the "hobby" drivers work on the Compumotor steppers? Or
>should I just figure on swapping them out?

They seem to be RS232 so no. Unless they have a step and direction
mode or something I'd swap them out but not before trying them with a
terminal program because that might be quick and fun.

Graham