Re: [CAD_CAM_EDM_DRO] Info on Jumping a PC power supply?
Posted by
David G. LeVine
on 2007-06-25 12:23:35 UTC
At 06:23 PM 6/23/2007, you wrote:
you, the fourth pin from the left edge on top should be the "magic"
one. Tie it to ground (on either side of it) and the power supply
SHOULD come up IF there is sufficient load. I use old sub 1GB hard
disks (which are of no further use) for dummy loads. PSON should be
a green wire, GROUND should be a black wire. +3.3 Volts should be
ORANGE wires on the left end. Of course, Dell made their own
(non-standard) variant of this.
David G. LeVine
Nashua, NH 03060
>I'm trying to jump out a pc power supply to run some stepper motors.If you look at the cable with the latch down and the sockets toward
>Does anyone know where I should install jumpers to power up a supply
>that is used on a desktop PC?
you, the fourth pin from the left edge on top should be the "magic"
one. Tie it to ground (on either side of it) and the power supply
SHOULD come up IF there is sufficient load. I use old sub 1GB hard
disks (which are of no further use) for dummy loads. PSON should be
a green wire, GROUND should be a black wire. +3.3 Volts should be
ORANGE wires on the left end. Of course, Dell made their own
(non-standard) variant of this.
David G. LeVine
Nashua, NH 03060
Discussion Thread
jeffspinner
2007-06-23 15:50:13 UTC
Info on Jumping a PC power supply?
Robert Colin Campbell
2007-06-23 15:56:21 UTC
Re: [CAD_CAM_EDM_DRO] Info on Jumping a PC power supply?
Jon Elson
2007-06-23 16:19:01 UTC
Re: [CAD_CAM_EDM_DRO] Info on Jumping a PC power supply?
Jon Elson
2007-06-23 16:19:51 UTC
Re: [CAD_CAM_EDM_DRO] Info on Jumping a PC power supply?
jeff spinner
2007-06-23 18:54:37 UTC
Re: [CAD_CAM_EDM_DRO] Info on Jumping a PC power supply?
Tony Smith
2007-06-23 22:29:18 UTC
RE: [CAD_CAM_EDM_DRO] Info on Jumping a PC power supply?
Mark Vaughan
2007-06-24 01:17:19 UTC
RE: [CAD_CAM_EDM_DRO] Info on Jumping a PC power supply?
Michael Fagan
2007-06-24 06:15:10 UTC
Re: [CAD_CAM_EDM_DRO] Info on Jumping a PC power supply?
Tony Smith
2007-06-25 04:20:54 UTC
RE: [CAD_CAM_EDM_DRO] Info on Jumping a PC power supply?
David G. LeVine
2007-06-25 12:23:35 UTC
Re: [CAD_CAM_EDM_DRO] Info on Jumping a PC power supply?
sam3216549872003
2007-07-01 00:02:29 UTC
Re: Info on Jumping a PC power supply?
Mike Pogue
2007-07-01 13:44:34 UTC
Re: [CAD_CAM_EDM_DRO] Re: Info on Jumping a PC power supply?
sam3216549872003
2007-07-06 11:52:18 UTC
Re: Info on Jumping a PC power supply?