CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Rong-Fu RF-45

Posted by ptengin@a...
on 2000-08-03 02:45:13 UTC
In a message dated 8/2/00 11:15:20 AM Hawaiian Standard Time,
tmay@... writes:

<< I looked at both Nook and THK but never found what you described,
except photos of commercial end blocks. >>

Terry,

Here is the link you need for the proper file at Nook. It is about 1.5 meg.
<A HREF="http://www.nookind.com/pdf/powertrac.pdf">http://www.nookind.com/pdf/
powertrac.pdf</A> It has very nice drawings. I will try to dig up some THK
or NSK drawings also. If that fails, I will get back to my shop and send you
some dwg's.

Peter
THRD, Inc.

Discussion Thread

Terry May 2000-07-30 11:12:50 UTC Rong-Fu RF-45 Dan Falck 2000-07-30 11:37:11 UTC Re: [CAD_CAM_EDM_DRO] Rong-Fu RF-45 Terry May 2000-07-30 12:54:00 UTC Re: Rong-Fu RF-45 Dan Falck 2000-07-30 13:01:48 UTC Re: [CAD_CAM_EDM_DRO] Re: Rong-Fu RF-45 Terry May 2000-07-30 13:38:57 UTC Re: Rong-Fu RF-45 ptengin@a... 2000-08-02 03:09:37 UTC Re: [CAD_CAM_EDM_DRO] Re: Rong-Fu RF-45 Terry May 2000-08-02 14:13:30 UTC Re: Rong-Fu RF-45 ptengin@a... 2000-08-02 17:45:48 UTC Re: [CAD_CAM_EDM_DRO] Re: Rong-Fu RF-45 ptengin@a... 2000-08-03 02:45:13 UTC Re: [CAD_CAM_EDM_DRO] Re: Rong-Fu RF-45