Re: [CAD_CAM_EDM_DRO] Re: Break out board with support for G320/G340 ERR output

Thanks for the info Tom but the board has a bit more functionality
than I was looking for.

Drew

caudlet wrote:

> Our EZPlug Dual Gecko Servo with the MTA100 interface can do that.
> Fault is logic or'd and output via opto to BOB input. Cards also have
> Gecko power-on-reset circuit, Filter caps, reverse polarity protection
> and single to differential encoder interfaces with a matching single
> ended to Diff pigtail for USDigital encoders. One card supports one
> or two G320's/340's.
>
> http://www.candcnc.com/ProductLine_Mini-IO-web.htm

--
Drew Rogge
drew@...