CAD CAM EDM DRO - Yahoo Group Archive

Re: shaft torsion ?

on 2008-03-19 08:19:37 UTC
Right, I am mistaken. I'm thinking about my own router project. In
view of that fact, a 1/2" shaft will be plenty adequate.

--- In CAD_CAM_EDM_DRO@yahoogroups.com, Kevin Martin <kpmartin@...>
wrote:
>
> In the original message the system was described as "5 foot wide
gantry on a plasma cutter" so there are essentially no machining loads
(unless you count the recoil from the plasma jet).
> -Kevin Martin
>
> -----Original Message-----
> From: CAD_CAM_EDM_DRO@yahoogroups.com
[mailto:CAD_CAM_EDM_DRO@yahoogroups.com] On Behalf Of carbonsteelsam
> [...]The real differential loads will result when the router is to
the extreme end of its travel and is under heavy cutting load.[...]
>

Discussion Thread

turbulatordude 2008-03-18 04:57:52 UTC shaft torsion ? Paul Kelly 2008-03-18 05:16:43 UTC RE: [CAD_CAM_EDM_DRO] shaft torsion ? Kevin Martin 2008-03-18 07:28:36 UTC RE: [CAD_CAM_EDM_DRO] shaft torsion ? cnc002@a... 2008-03-18 08:44:16 UTC Re: [CAD_CAM_EDM_DRO] shaft torsion ? turbulatordude 2008-03-18 10:52:08 UTC Re: shaft torsion ? carbonsteelsam 2008-03-18 15:42:13 UTC Re: shaft torsion ? Kevin Martin 2008-03-18 19:09:42 UTC RE: [CAD_CAM_EDM_DRO] Re: shaft torsion ? carbonsteelsam 2008-03-19 08:19:37 UTC Re: shaft torsion ? Philip Burman 2008-03-19 10:54:38 UTC Re: shaft torsion ? carbonsteelsam 2008-03-19 13:40:08 UTC Re: shaft torsion ? Philip Burman 2008-03-21 04:20:24 UTC Re: shaft torsion ? carbonsteelsam 2008-03-21 08:11:24 UTC Re: shaft torsion ? Jon Elson 2008-03-21 09:28:40 UTC Re: [CAD_CAM_EDM_DRO] Re: shaft torsion ? Philip Burman 2008-03-21 18:54:27 UTC Re: shaft torsion ? carbonsteelsam 2008-03-23 08:10:52 UTC Re: shaft torsion ? gcode fi (hanermo) 2008-03-24 08:26:55 UTC Re: [CAD_CAM_EDM_DRO] Re: shaft torsion ? metlmunchr 2008-04-20 21:58:18 UTC Re: shaft torsion ?