Re: [CAD_CAM_EDM_DRO] Ballscrew machining
Posted by
NEVILLE WEBSTER
on 2008-04-12 16:51:40 UTC
sound advice Steve,
take a cut and don't let tool dwell, use a power feed if possible. Machinist often make this mistake and don't get the best out of cutting tools.
Neville
----- Original Message ----
From: Steve Blackmore <steve@...>
To: CAD_CAM_EDM_DRO@yahoogroups.com
Sent: Sunday, 13 April, 2008 12:47:08 AM
Subject: Re: [CAD_CAM_EDM_DRO] Ballscrew machining
take a cut and don't let tool dwell, use a power feed if possible. Machinist often make this mistake and don't get the best out of cutting tools.
Neville
----- Original Message ----
From: Steve Blackmore <steve@...>
To: CAD_CAM_EDM_DRO@yahoogroups.com
Sent: Sunday, 13 April, 2008 12:47:08 AM
Subject: Re: [CAD_CAM_EDM_DRO] Ballscrew machining
On Sat, 12 Apr 2008 15:22:47 -0700, you wrote:
>Good advice but I recommend that you also not try to take an interupted cut because that will damage the carbide insert. I try to under cut the hardened area of the outer surface in one cut
Hi Dan - depends entirely on the insert and carbide grade. Correct
choice of insert and interrupted cuts aren't a problem.
Steve Blackmore
--
[Non-text portions of this message have been removed]
Discussion Thread
john_glynn57
2008-04-12 08:24:01 UTC
Ballscrew machining
stan
2008-04-12 08:44:21 UTC
Ref: Ballscrew machining
Torsten
2008-04-12 08:50:19 UTC
Re: Ballscrew machining
stan
2008-04-12 08:55:35 UTC
Ref: Ballscrew machining
gary burke
2008-04-12 09:04:19 UTC
Re: [CAD_CAM_EDM_DRO] Ref: Ballscrew machining
JanRwl@A...
2008-04-12 09:23:24 UTC
Re: [CAD_CAM_EDM_DRO] Ballscrew machining
Jon Elson
2008-04-12 11:34:20 UTC
Re: [CAD_CAM_EDM_DRO] Ballscrew machining
R Rogers
2008-04-12 13:47:21 UTC
Re: [CAD_CAM_EDM_DRO] Ballscrew machining
Dan Mauch
2008-04-12 15:22:46 UTC
Re: [CAD_CAM_EDM_DRO] Ballscrew machining
Steve Blackmore
2008-04-12 16:47:12 UTC
Re: [CAD_CAM_EDM_DRO] Ballscrew machining
NEVILLE WEBSTER
2008-04-12 16:51:40 UTC
Re: [CAD_CAM_EDM_DRO] Ballscrew machining
carbonsteelsam
2008-04-13 08:37:48 UTC
Re: Ballscrew machining
john_glynn57
2008-04-13 14:06:26 UTC
Re: Ballscrew machining
Steve Blackmore
2008-04-13 16:57:20 UTC
Re: [CAD_CAM_EDM_DRO] Re: Ballscrew machining
john_glynn57
2008-04-14 07:49:13 UTC
Re: Ballscrew machining